Cangzhou Xinglong Engineering Instrument Co

Type mortar mixer mixer mixer wholesale price
The mortar mixer is a special equipment designed to cooperate with the promotion and implementation of the national Ministry of Construction (Ministry of Construction) basic performance test method standards for construction mortar. It is mainly used in the construction industry. Mixing machinery used in colleges, universities, scientific research units, and quality inspection departments to test the strength of wall powder materials and mortar for brick walls. It is also suitable for the production of artificial marble fabrics and other powdery mixing work. It has two relative rotations: the mixing blade moves clockwise and the mixing drum moves counterclockwise. Therefore, it has the characteristics of uniform mixing, short mixing time, high efficiency, and easy operation.
[Technical Parameters]
, Mixing blade: layer
, Mixing blade running diameter:
, Mixing blade speed: (clockwise) r
, Mixing drum speed : (counterclockwise) r
, Mixing drum capacity:
, Mixing drum rated capacity: (discharging)
, Mixing drum inner diameter:
, Mixing drum depth:
, The gap between the fixed blade and the mixing drum wall.
, The gap between the stirring blade and the bottom of the mixing drum.
, Voltage and power:
[Structure and principle]
, This equipment has It consists of box body, motor, worm gear box, gear box, blades, scraper, cylinder, worm frame and programmable controller. See (Figure 1)
The transmission type of this machine is that the motor is connected to the worm gear box to drive the worm gear. The upper end of the worm gear shaft drives the mixing drum to rotate counterclockwise through the clutch. The output gear at the lower end of the worm gear shaft is coupled with the gear at the lower end of the column. The upper gearbox driving gear is driven by the coupling on the vertical shaft, and the mixing gear is driven by the intermediate gear to drive the mixing blade to rotate clockwise. The specific transmission procedure is: mixing drum speed
[Operation and use]
First, ( ) Put down the gear box, press the program controller switch, run idle, and check whether the steering is consistent with the stated direction. After parking, check whether the clearance between the () scraper and the wall of the mixing drum and the bottom of the mixing drum is correct. After adjustment, tighten the mixing blade nut, put the materials prepared in proportion into the drum, start the mixing, and then slowly pour an appropriate amount of water into the drum. , after pouring in the materials and mixing evenly, stop the machine and trigger the turning mechanism, tilt the cylinder at an angle, and take out the materials for use. When resetting the mixing cylinder after each mixing and discharging, be sure to check whether the positions of the bottom of the cylinder and the base are correct. Otherwise, do not turn it on.
【Maintenance and Maintenance】
This unit should be placed in a dry environment without any corrosive media.
After use, be sure to clean the inside of the cylinder and the stirring blade with clean water and dry them. (If you have not used it for a long time, you can apply anti-rust oil on the interior and blade surface.)
Always pay attention to whether the fasteners are loose after use, and tighten them in time.
When feeding, it is strictly forbidden to insert nails, wires and other hard objects into the cement and sand to avoid damaging the machinery.
After the reduction gearbox has been used for a period of time, check the lubricating oil level and replenish it in time with mechanical oil of # quality until the oil level can be seen through the observation hole